Seals in PurgeX pumps normally operate over millions of cycles without significant wear. The majority of applications do not require seal replacement.
This Buna Seal Replacement Kit is suitable for PurgeX models:
· B3559-106X08
· B3559-106X12
· B3559-106X24
· B3559-106X36
· Other 6 feed Spray PurgeX models starting in “B3559-106X” of any nozzle length.
Replacement Procedure
PurgeX seals should be carefully replaced in a clean environment. Remove the current seals from the unit. Was the remaining components with mineral spirits and allow them to dry completely. Apply a light coat of oil to the new seals before assembling. Step by step assembly instructions can be downloaded using the link on this page.
Note: If the evacuation valve (A7440-1) is removed from the assembly at any time, it must be replaced with a new evacuation valve or the warranty is void.
Supplied Components:
Key
Part
Material
Location
Qty
A
A2699-1
Buna
Adjustment Stem
6
B
A2699-13
Adjustment Cap
C
A4939-17
Return Spring
D
A2699-6
Piston Bore (Stationary Seal)
E
A4213-39
Viton
Shuttling O-Ring
F
A4213-38
Lower Piston Groove
G
A7440-1
Buna, Brass
Evacuation Valve Assembly
H
A5180-1
Retaining Sleeve
I
A4213-29
Vertical Air Shaft
J
A2699-33
Spray Manifold Plate
K
A2699-10
Nozzle Fitting
L
A2699-3
Air Adjustment Cap
M
Air Adjustment Stem
Z
A2699-9
Adapters/Threadapters
14