This sturdy gage is made of rust and corrosion resistant milled aluminum.  The end pieces are permanently secured through a staking process.  The unit tolerates up to 175 PSI and 225° F.  The liquid viewing sight is glass.  Leak-proof construction is achieved with Buna-N seals.  Temperature is indicated with red fluid in both degrees Fahrenheit and Celsius on the 8 1/2” tall aluminum and glass thermometer.  It displays -20° to 220° F and -25° to 100° C. 

Fluid enters through the cross hole in the hollow lower bolt.  The gage is vented into the tank through the top bolt.  The length between the center of the two bolts is referred to as the center line.  The distance between the center of the tank holes must be within 1/32” of the center line measurement.  This gage is mounted from the front of the tank with (2) 1/2”-20 aluminum bolts.  The mounting bolts should be torqued to 90 in-lbs.

The brass stems can be adjusted to stop fluid flow into the gage.  This can be used as a precautionary measure if breakage is a concern.  Should the gage need to be replaced, the aluminum hex nuts unscrew and the gage can be removed without draining the tank.  Once a gage has been placed back onto the bolts and secured with hex nuts, the shut off valves can be opened and the gage will resume normal function.

For additional mounting options, seals and fractional inch centerline distances, reference the “Other Options” document located on this page.